Panasonic TH-42PF50E Operating Instructions Manual page 52

Setup for Input Signals
• Sync
This function operates only during input from PC IN terminal.
Setting RGB sync signal
Con¿ rm that the input is set to RGB input (this setting is valid only for RGB input signal).
Auto: The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.
on G: Uses a synchronized signal on the Video G signal, which is input from the G connector.
Setting Component sync signal
Con¿ rm that the input is set to Component input (this setting is valid only for Component input signal).
Auto: The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.
on Y: Uses a synchronized signal on the Video Y signal, which is input from the Y connector.
Note:
Signals input to COMPONENT/RGB IN terminals correspond to Sync on G or Sync on Y.
• SDI Through
Set the active through function of the Dual Link HD-SDI Terminal Board (TY-FB11DHD).
On Off
On: Enables active through.
Off: Disables active through.
Note:
Settings can only be performed for this menu when a slot mounted with a Dual Link HD-SDI Terminal Board
(TY-FB11DHD) is selected.
• FRAME CREATION
Automatically compensates the picture frame rate and removes juddering movements to make the images
smooth.
Off Mid Max
Note:
Depending on the contents, images may be noisy. To prevent the noise, change the setting.
• 3D Refresh Rate
Reduces juddering or À icker of image due to lighting interference during 3D viewing.
100Hz 120Hz
Note:
This setting is disabled when "FRAME CREATION" is set to "Off".
• HDMI Range
Switches the dynamic range according to the input signal from HDMI terminal.
Video(16-235) Full(0-255)
Video(16-235): If the input signal is the video range, Example: HDMI terminal output for DVD player
Full(0-255): If the input signal is full range, Example: HDMI terminal output for personal computer
Auto: Switches the dynamic range automatically between "Video(16-235)" and "Full(0-255)" according to the input signal.
Note:
This function can be set only for HDMI signal input.
52
Auto