Selecting The Input Signal - Panasonic TH-42PF50E Operating Instructions Manual

Selecting the input signal

Press to select the input signal to be played back from the equipment which has
been connected to the Plasma Display.
Input signals will change as follows:
PC NETWORK
PC: PC input terminal in PC IN.
NETWORK: Network input terminal in LAN or WIRELESS MODULE.
VIDEO: Video input terminal in AV IN (VIDEO).
COMPONENT*: Component or RGB input terminal in COMPONENT/RGB IN.
HDMI: HDMI input terminal in AV IN (HDMI).
DVI: DVI input terminal in DVI-D IN.
* "COMPONENT" may be displayed as "RGB" depending on the setting of
"Component/RGB-in select". (see page 50)
When an optional Terminal Board is installed:
PC NETWORK
SLOT INPUT: Input terminal in Terminal Board
Note:
When a Terminal Board incompatible with the Plasma Display is installed,
"Non-Compatible Function Board" is displayed.
When a Terminal Board with dual input terminals is installed:
PC NETWORK
SLOT INPUT A, SLOT INPUT B: Dual input terminal in Terminal Board.
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Outputs the sound as set in "Audio input select" in the Options menu. (see page 59)
• Select to match the signals from the source connected to the component/RGB input terminals. (see page 50)
• Image retention (image lag) may occur on the plasma display panel when a still picture is kept on the panel for an
extended period. The function that darkens the screen slightly is activated to prevent image retention (see page 62),
but this function is not the perfect solution to image retention.
VIDEO COMPONENT*
SLOT INPUT VIDEO
SLOT INPUT A SLOT INPUT B
HDMI DVI
COMPONENT HDMI
VIDEO COMPONENT
DVI
INPUT MENU -/ VOL + / ENTER/
INPUT MENU -/ VOL
HDMI DVI
+
/ ENTER/
17