Panasonic WJ-NV200K Installation Manual page 53

Rec.: Output of the alarm signal will continue during
event recording.
Default: 2 s
[Auto reset time]
Set the time for automatically resetting the alarm action.
2 s/ 5 s/ 10 s/ 20 s/ 30 s/ 1 min/ 3 min/ 5 min
Ext.: Alarm output will continue until the alarm action is
reset. Refer to the operating instructions (PDF) for
further information about alarm reset.
Default: Ext.
Note:
• If the time set for "Output duration" or "Buzzer duration"
is longer than that set for "Auto reset time", the time set
for "Auto reset time" will be applied.
Set up terminal alarm [Advanced terminal alarm setup]
Configure the settings relating to the recording triggered by an alarm signal supplied to the ALARM/CONTROL connector of the
recorder from an external alarm device such as a door sensor.
Configure the necessary settings for each alarm input terminal of the ALARM/CONTROL connector on the rear panel of the
recorder.
■ Advanced terminal alarm setup
[Mode]
Select the action to be taken when an alarm signal is sup-
plied.
Recording & alarm action: All event actions will be per-
formed according to the settings.
Recording only: Only recording, filing of event logs, and
moving the camera to a preset position will be per-
formed.
Off: Only filing of event logs will be performed.
Default: Recording & alarm action
[Setup by terminal]
Set up individual terminals numbered from 1 to 9.
[Recording camera]
Select the camera for recording. When "Off" is selected,
recording will not be performed.
Default: Camera number associated with the terminal num-
ber
[Message display]
Select whether or not to display a message on a PC con-
nected to a network when an alarm occurs.
On: Display a message.
Off: Does not display a message.
Default: On
■ Advanced event setup
Configure advanced settings for individual alarm types (ter-
minal alarm, camera site alarm, command alarm, and face
matching alarm*). Clicking the [Advanced >] button for each
item will open the respective "Advanced setup" .
[Preset]
Select the camera preset position (001 to 256) to which the
camera is to be moved with an alarm signal is received. If
"---" is selected, the camera will not be moved to a preset
position.
[Terminal output]
Choose whether or not to output an alarm signal from the
alarm output terminal of the ALARM/CONTROL connector
on the recorder's rear panel when an alarm signal is
received.
On: Outputs alarm signals.
Off: Does not output alarm signals.
Default: On
[Terminal input]
Select the terminal status for supplying an alarm signal to the
alarm terminal.
N.O. (Normally Open): Signals will be supplied when
short-circuited.
N.C. (Normally Close): Signals will be supplied when
open-circuited.
Default: N.O.
[Back] button
Click the button after completing the settings. The screen
returns to the [Event setup] tab.
53