Event Recording - Panasonic WJ-NV200K Installation Manual

Configure the advanced settings for schedule recording
In addition to schedule recording, up to 3 event recordings each can be set up on Time table 1 and 2.
Clicking the [Advanced >] button in the "Schedules" field will open the "Advanced schedule setup" page.
■ Days to record
Select the actions to be taken on each day of the week
based on a time table. [ a ] indicates the selected state, [ b ]
the unselected state.
Time table1: Recording according to Time table 1.
Time table2: Recording according to Time table 2.
Off: Neither schedule nor event recording will take place.

■ Event recording

Set the recording duration in the event that an alarm occurs
and the recording duration before an alarm occurs.
[Event recording duration]
Set the recording duration in the event that an alarm occurs.
2 s/ 5 s/ 10 s/ 20 s/ 30 s/ 1 min/ 2 min/ 3 min/ 5 min/ 10
min/ 15 min
Manual: Recording will continue while receiving an alarm
input signal. Recording will be performed for at least
8 seconds.
Ext.: Alarm output will continue until the alarm action is
reset.
Default: 30 s
[Pre-event duration]
Set the recording duration before an alarm occurs.
0 s/ 5 s/ 10 s/ 15 s
Default: 0 s
Note:
• The actual recording time may sometimes be longer
than the duration selected for this setting.
• Pre-event recording is not performed when "0 s" is
selected.
• When images are set to be recorded together with
audio, the audio may not be recorded at the beginning
of the pre-event recording.
■ Schedule to record
3 schedule recordings and 3 event recordings each can be
set up on Time table 1 and 2. Within the same time table,
event recording has priority over schedule recording.
[Schedule recording] (☞ Page 50)
[HDD saving mode] (☞ Page 50)
[Event recording]
Set the time table for recording in the event that an alarm
occurs. Alarm that falls into a time table that has not been
set up will not trigger recording. Refer to page 50 for how to
configure the time bar.
[e-Mail]
To send an alarm e-mail when an event occurs, mark this
item.
[Panasonic alarm protocol]
Mark the checkbox of this item to automatically transmit
information on an event that occurs to a PC using the
Panasonic alarm protocol.
[Back] button
Click the button after completing the settings. The screen
returns to the [Recording setup] tab.
51