Positioning The Logset; Installing The Log Set - Montigo B34DV Installation & Maintenance Manual

B-Series DV-2 Gas Fireplace

Installing the Log Set

Installing the Logs:
The B-Series DV2 is supplied with five ceramic fibre logs. Unpack the
logs and handle them very carefully.
1. Remove the door cover and the glass door.
2. Place the Back log onto the back log rest as shown below in figure
29. The log has lip on the bottom which fits into the slot on the log rest.
Place the Front log onto the front log rest as shown in figure 29.
3.
Center the log from side to side, and push it against the back of the
log rest. Carefully push the log onto the metal spikes on the log rest.
4. Place the top logs in position as shown in figure 29a, place the
centre log down first, then the right and left logs.
5. Start the fireplace. If the flame appears satisfactory, replace the
glass door and door cover.
Figure 29. Positioning for the front and back logs.
Figure 29a. Proper log placement.
Cautions:
If logs are not placed properly, excessive sooting will result.
Q
The surface of the logs will crack due to the heat of the
Q
flames. This is a normal occurrence.
Page 16
Installation
Part No. XG0160 - 080410