Removing And Installing The Door; Installing The Horizontal Trim - Montigo B34DV Installation & Maintenance Manual

Operation - Model B-Series DV-2
Removing the door:
Remove the trim (as described in the next column) to access the door latches. Open the latches by pulling Part A upwards and towards you to
disengage Part B from the door. Lift Part B clear of the door. Repeat for both latches. Be sure to hold the door carefully so it does not fall. (See
figure 28a.)
Figure 28a. Removing and installing the glass door.
Figure 28b. Removing and installing the glass door.
Figure 28c. Removing and installing the glass door.
Part No. XG0160 - 080410

Removing and Installing the Door

Re-installing the door:
To re-install the door, tilt the top edge towards you and line up the tabs
of the bottom of the door with the slots on the fireplace. Place the tabs
into the slots, and tilt the top of the door back towards the fireplace as
far as it will go. Close the latches by hooking Part B onto the groove at
the top of the door and pushing Part A down completely.
Installing the Trim & Baffle
Installing the Logs:
The 6 horizontal trim pieces (3 upper and 3 lower) are purchased separate
from the fireplace, and must be field-installed.
Install the trim by placing the top edge of the trim over to the retainer clips
on either side of the fireplace. Push the bottom edge firmly inwards and
the trim will snap on. (See figure 29) Install the upper trim pieces so that
the baffle is resting between the top and middle piece, as shown below.
The trim piece with the Montigo Emblem should be installed on the lower
middle clips with the emblem on the right side.
B-Series DV-2 Gas Fireplace
Please note: Latch style may vary on some
models.
Page 15