Mazda CX-9 Owner's Manual page 259

CX-9_8CM9-EA-12I_Edition1 Page259
Thursday, September 13 2012 2:36 PM
The HomeLink system provides 3 buttons
which can be individually selected and
programmed using the transmitters for
current, on-market devices as follows:
1. Position the end of your hand-held
transmitter 2.5 7.5 cm (1 3 inches)
away from the HomeLink button you
wish to program while keeping the
indicator light in view.
2. Simultaneously press and hold both the
chosen HomeLink and hand-held
transmitter buttons. Do not release the
buttons until step 3 has been
completed.
NOTE
Some gate operators and garage door openers
may require you to replace this Programming
Step 2 with procedures noted in the Gate
Operator/Canadian Programming section.
3. After the HomeLink indicator light
changes from a slow to a rapidly
blinking light, release both the
HomeLink and hand-held transmitter
buttons.
NOTE
If the HomeLink indicator light does not
change to a rapidly blinking light, contact
HomeLink at www.homelink.com or call 1-
800-355-3515 for assistance.
4. Firmly press and hold the programmed
HomeLink button for five seconds, and
then release it. Perform this operation
two times to activate the door. If the
door does not activate, press and hold
the just-trained HomeLink button and
observe the indicator light.
If the indicator light stays on constantly,
programming is complete and your
device should activate when the
HomeLink button is pressed and released.
Form No.8CM9-EA-12I
Black plate (259,1)
Switches and Controls
NOTE
To program the remaining two HomeLink
buttons, begin with Programming
If the indicator light blinks rapidly for
two seconds and then turns to a
constant light, continue with
Programming steps 5 7 to complete
the programming of a rolling code
equipped device (most commonly a
garage door opener).
5. At the garage door opener receiver
(motor-head unit) in the garage, locate
the learn or smart button. This can
usually be found where the hanging
antenna wire is attached to the motor-
head unit.
6. Firmly press and release the learn or
smart button. (The name and color of
the button may vary by manufacturer.)
NOTE
There are 30 seconds in which to initiate step
7.
7. Return to the vehicle and firmly press,
hold for two seconds and release the
programmed HomeLink button. Repeat
the press/hold/release sequence a
second time, and, depending on the
brand of the garage door opener (or
other rolling code equipped device),
repeat this sequence a third time to
complete the programming process.
HomeLink should now activate your
rolling code equipped device.
NOTE
To program the remaining two HomeLink
buttons, begin with Programming
For questions or comments, please contact
HomeLink at www.homelink.com or 1-
800-355-3515.
Driving Your Mazda
step 1.
step 1.
5-83