QUICK SETUP
1.
Insert two AAA batteries into the
Remote Control Sender.
2.
Insert two AAA batteries into the
Indoor Temperature Station.
3.
Wait 5-6 minutes, or until the outdoor
temperature
OUTDOOR LCD of the Temperature
Station.
4.
Set the Time
5.
Mount units.
(See complete instructions for details).
Note: The Remote Control Sender transmits
a signal every 3 minutes. After the batteries
have been installed, the Indoor Temperature
Station searches for these signals for a
duration of 6 minutes.
temperature reading in the OUTDOOR LCD
after 6 minutes, make sure the units are
within range of each other, or repeat battery
installation process.
is
displayed
If there is no
in
the
2