Table of Contents
Advertisement
Quick Links
WS-7213U Wireless 433 MHz Weather Station Instruction Manual
TABLE OF CONTENTS
Topic
Inventory of Contents
Additional Equipment
Quick Setup
Detailed Setup Guide
Battery Installation
Setting the Time
Features
Minimum and Maximum Temperatures
Resetting Minimum and Maximum Temperatures
Weather Forecast and Weather Tendency Arrows
Adding additional remote temp/humidity sensors (optional)
Viewing and operating multiple remote temp/humidity sensors
Mounting
Troubleshooting
Maintenance and Care
Specifications
Warranty Information
INVENTORY OF CONTENTS
1.
The indoor weather station (Figure 1)
2.
The remote temperature/humidity sensor (TX4U) and mounting bracket. (Figure 2)
3.
Mounting hardware.
4.
Instruction Manual and Warranty Card.
Figure 1
Figure 2
Page
3
4
5-8
9-11
11
12-13
13
14-17
17-19
19-20
21-22
23-26
26
27-28
29-31
Advertisement
Table of Contents
Related Manuals for La Crosse Technology WS-7213U
Summary of Contents for La Crosse Technology WS-7213U
- Page 1 WS-7213U Wireless 433 MHz Weather Station Instruction Manual TABLE OF CONTENTS Topic Inventory of Contents Additional Equipment Quick Setup Detailed Setup Guide Battery Installation Setting the Time Features Minimum and Maximum Temperatures Resetting Minimum and Maximum Temperatures Weather Forecast and Weather Tendency Arrows...
-
Page 2: Additional Equipment
DO NOT PRESS ANY BUTTONS FOR 15 MINUTES. In this time the indoor weather station and remote temp/humidity sensor will start to talk to each other and the displays will show both the indoor temperature and an outdoor temperature and humidity. If the indoor weather station do not display both the indoor temperature and the outdoor temperature and humidity after the 15 minutes please retry the set up as shown on page five. -
Page 3: Minimum And Maximum Temperatures
The weather forecasting feature is estimated to be 75% accurate. The weather forecast is based solely upon the change of air pressure over time. The WS-7213U averages past air-pressure readings to provide an accurate forecast—creating a necessity to disregard all weather forecasting for 12-24 hours after the unit has been set-up, reset, or moved from one altitude to another (i.e. -
Page 4: Adding Additional Remote Temp/Humidity Sensors (Optional)
The WS-7213U is able to receive signals from 3 different remote temperature, temperature/humidity sensors. Following are some brief instructions for the basic set-up of remote sensor units with the WS-7213U. These extra sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. -
Page 5: Mounting
Reattach the remote temp/humidity sensor to the mounting bracket. THE WEATHER STATION The indoor weather station comes with the table stand already mounted. If you wish to use the table-stand, all that is required is to place the indoor weather station in your desired location. -
Page 6: Maintenance And Care
The indoor sensor is less responsive to ambient air currents because of the shielding effect of the indoor weather station’s case. In addition, the casing can act as a heat sink to absorb and store heat from external sources (i.e. handling of the case or radiant heat). -
Page 7: Warranty Information
Before sending the weather station in for repairs, contact La Crosse Technology. The weather station will be repaired or replaced with the same or similar model. This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty batteries, or the weather stations inability to receive a signal due to any source of interference.