TABLE OF CONTENTS Introduction……………………………………………………………………………………..3 Inventory of Contents…………………………………………………………………………4 Quick Set Up……………………………………………………………………………………4 Detailed Set Up………………………………………………………………………………4-5 Battery Installation…………..………………………………………………………..4-5 12 or 24 Hour Time Display………..…………………………………………………..5 Time Setting………..……..…………………………………………………………….5 Features……………………………………………………………………………………….6-7 Minimum & Maximum Temperature and Humidity……………………..……………6 Resetting Minimum & Maximum Temperature and Humidity………..…………….6 Adding Additional Thermo-Hygro Sensors……………………………..…………….6 Viewing &...
Page 3
This product offers: INSTANT TRANSMISSION is the state-of- the-art wireless transmission technology, exclusively designed developed by LA CROSSE TECHNOLOGY. INSTANT TRANSMISSION offers you an immediate update (every 4 seconds!) of all your outdoor data measured from the transmitters: follow your climatic...
feet of resistance and an interior wall will have up to 10 feet of resistance. Your distance plus resistance should not exceed 330 feet in a straight line. NOTE: Fog and mist will not harm your thermo-hygro sensor, but direct rain must be avoided.
Battery Cover Battery Compartment Sensor signal reception icon* * When the signal is successfully received by the Weather Station, the icon will be switched on. (If not successful, the icon will not be shown in LCD) So the user can easily see whether the last reception was successful (icon on) or not (icon off).
MIN/MAX button for 5 seconds. C. ADDING ADDITIONAL REMOTE SENSORS (OPTIONAL) The WS-7220U-IT is able to receive signals from 2 additional thermo-hygro sensors. The following are instructions for the set-up of thermo-hygro sensor units with the WS- 7220U-IT. These extra sensors can be purchased through the same dealer as this unit.
NOTE: You must insert the batteries into the third sensor within 30 seconds of reception of the second sensor. IMPORTANT: Transmission problems will arise if the setting for multiple sensors is not followed as described above. Should transmission problems occur, it is necessary to remove the batteries from all units and start again the set-up from step 1.
Gently pull the Wireless Weather Station down to lock the screw into place. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www.lacrossetechnology.com Problem: The LCD is faint Solution: Replace batteries Problem: No outdoor temperature is displayed.
• Do not subject the units to unnecessary heat or cold by placing them in the oven or freezer. • Opening the casings invalidates the warranty. Do not try to repair the unit. Contact La Crosse Technology for repairs. SPECIFICATIONS Transmitting...
Technology, Ltd or La Crosse Technology, Ltd’s authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above.
Page 12
LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION.
Page 13
FCC ID: OMOTX29UTH (transmitter) RF Exposure mobile: The internal / external antennas used for this mobile transmitter must provide a separation distance of at least 20 cm (8 inches) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter." Statement according to FCC part 15.19: This device complies with Part 15 of the FCC Rules.