Table of Contents
Advertisement
place, all segments of the LCD will light up briefly. Following time as
12:00 and the indoor temperature will be displayed. If they are not
shown in LCD after 60 seconds, remove the batteries and wait for
at least 60 seconds before reinserting them.
4.
The outdoor temperature from the first sensor (channel 1) should
then be displayed on the Temperature Station. Also, the signal
reception icon will be displayed. If this does not happen after 2
minutes, the batteries will need to be removed from both units and
reset from step 1.
5.
Insert the battery into the second sensor immediately after (within
10 seconds after) inserting battery to the Temperature Station.
6.
The outdoor temperature from the second sensor and the "channel
2" icon should then be displayed on the Temperature Station. If this
does not happen after 2 minute, the batteries will need to be
removed from all the units and reset from step 1.
7.
Insert the batteries into the third sensor immediately after (within
10 seconds after) inserting battery to the second sensor.
8.
Then within 2 minutes, the channel 3 outdoor data from the third
sensor will be displayed and the channel icon will shift back to "1"
once the third sensor is successfully received. If this is not happen,
user shall restart the setting up from step 1.
9.
In order to ensure sufficient 915 MHz transmission there should be
a distance of no more than 330 feet (100 meters) between the final
position of the Temperature Station and the sensor (see notes on
"Mounting" and "915 MHz Reception").
Note:
After the three sensors have been set up, user may need to check the
readings displayed on the Temperature Station against those being shown
on the sensor displays, in order to recognize which channel each sensor is
displayed.
4
Hide quick links:
Advertisement
Table of Contents
