La Crosse Technology WS-9117U-IT Instruction Manual page 14

ADDING ADDITIONAL REMOTE
SENSORS (OPTIONAL)
The WS-9117U-IT is able to receive signals
from 2 additional temperature sensors. The
following are instructions for the set-up of
temperature sensor units with the WS-9117U-
IT. These extra sensors can be purchased
through the same dealer as this unit.
1. Remove all the batteries from the
receiver and sensor(s) and wait 60
seconds. During these 60 seconds,
press any button 20 times to discharge
any excess power.
2. Insert the batteries to the first
temperature sensor.
3. Within 2 minutes of powering up the first
sensor, insert the batteries to the
Temperature Station. Once the batteries
are in place, all segments of the LCD will
light up briefly. Following the indoor
temperature and the time as 12:00 will
be displayed. If they are not shown in
LCD after 60 seconds, remove the
batteries and wait for at least 60 seconds
before reinserting them.
4. The outdoor temperature from the first
sensor (channel 1) should then be
displayed on the Temperature station. If
14