Table of Contents
Advertisement
To complete the set up of your Wireless Weather Station after the 15 minutes have passed
please follow the steps that follow in the Detailed Set-Up Guide.
DETAILED SET-UP GUIDE
I.
BATTERY INSTALLATION (When one temperature sensor is being used)
1.
First, insert the batteries to the temperature sensor (see "A. Remote Temperature
Sensor" below).
2.
Within 30 seconds of powering up the sensor, insert the batteries to the Weather
Station (see "B. Wireless Weather Station" below). Once the batteries are in place, all
segments of the LCD will light up briefly. Following the indoor temperature, and the
time as 12:00 will be displayed. If they are not shown in LCD after 60 seconds, remove
the batteries and wait for at least 60 seconds before reinserting them. Once the indoor
data is displayed user may proceed to the next step.
3.
After the batteries are inserted, the Weather Station will start receiving data signal
from the sensor. The outdoor temperature should then be displayed on the Weather
Station. If this does not happen after 2 minutes, the batteries will need to be removed
from both units and reset from step 1 and the signal reception icon is no longer shown.
A. REMOTE TEMPERATURE SENSOR
1.
Remove the mounting bracket. The bracket snaps on
and off easily.
2.
Remove the battery cover, by sliding the cover down.
3.
Observing the correct polarity install 2 AA batteries. The
batteries will fit tightly (to avoid start-up problems make
sure they do not spring free).
4.
Replace the battery cover by sliding upwards. Be sure
battery cover is on securely.
B. WIRELESS WEATHER STATION
1.
Remove the battery cover. To do this, insert a solid object in the space provided
at the lower-central position of the battery cover, then push up and pull out on the
battery cover.
2.
Observe the correct polarity, and install 2 AA batteries.
3.
Replace the battery cover.
Battery
Cover
5
Battery
Cover
Sensor signal
reception icon*
Hide quick links:
Advertisement
Table of Contents
