Table of Contents
Advertisement
3) Be sure the atomic clock is at least 6 feet (2 meters) from any electrical
devices, i.e. TV sets, computers, or other radio controlled clocks.
4) Remove batteries for five minutes, reinsert and leave the unit alone
overnight without pressing any keys.
Problem:
Hour is incorrect (minute and date are correct).
Solution:
1)
Be sure the correct time zone and daylight saving time are selected.
Problem:
"OFL" appears in the indoor temperature section of the LCD
1) Move the atomic clock to an area with warmer or cooler surrounding
Solution:
temperature. Current surrounding temperatures are outside measuring
range.
Problem:
"--.-" appears in the outdoor temperature section of the LCD.
1) Remove the batteries of both units for one minute, then reinsert them
Solution:
again. Make sure the batteries are new and fresh.
2) Move the atomic clock closer to the transmitter or place the transmitter
closer to the atomic clock. Make sure the clock is at a receivable range
from the transmitter.
3) Move the units to another location. Interferences from other electrical
devices operating on the same signal frequency (433MHz) may prevent
correct signal transmission and reception.
Problem:
"OFL" appears in the outdoor temperature section of the LCD.
Solution:
1) Wait until the current surrounding temperature cools down or increases.
Current temperature is outside of the measuring range of the transmitter.
The outdoor temperature will be displayed again once the current
surrounding temperature is within the range of the transmitter.
CARE AND MAINTENANCE:
• Avoid placing the units in areas prone to vibration and shock as these may cause damage.
• Avoid areas where the units can be exposed to sudden changes in temperature, i.e. direct
sunlight, extreme cold and wet/moist conditions as these will lead to rapid changes which reduces
the accuracy of readings.
• When cleaning the LCD and casing, use a soft damp cloth only. Do not use solvents or scouring
agents.
• Do not submerge the units into water.
• Immediately remove all low powered batteries to avoid leakage and damage. Replace only with
new batteries of the recommended size.
• Do not make any repairs to the units. Please return it to the original point of purchase. Opening
and tampering with the units may invalidate the warranty.
SPECIFICATIONS:
Temperature measuring range
Indoor: +14.1ºF to +99.8ºF with 0.2ºF resolution
-9.9ºC to +37.6ºC with 0.1ºC resolution
("OFL" displayed if outside this range)
Outdoor : -21.8ºF to +157.8ºF with 0.2ºF resolution
-29.9ºC to +69.9ºC with 0.1ºC resolution
("OFL" displayed if outside this range)
Temperature checking interval
Indoor: every 10 seconds
Outdoor: every 5 minutes
Humidity measuring range
Indoor: 1-99%
Transmission distance: maximum 330 feet (100 meters) in open field
Power source (Alkaline batteries recommended)
Atomic clock : 3 x AA, 1.5V batteries
Transmitter: 2 x AA, 1.5V batteries
Battery life: about 12 months
Dimensions (H x W x D)
Atomic clock: 11.75" x 12" x 1.25" / 299 x 305 x 32 mm
Transmitter: 5.04" x 1.57" x 0.9" / 128 x 40 x 23 mm
LIABILITY DISCLAIMER:
• The manufacturer and supplier cannot accept any responsibility for any incorrect readings and any
consequences that occur should an inaccurate reading take place.
• This product is only designed for use in the home or office.
• This product is not to be used for medical purposes or for public information.
• The specifications of this product may change without prior notice.
• This product is not a toy. Keep out of the reach of children.
Hide quick links:
Advertisement
Table of Contents
