Set Features Command - Seagate ST4000DM000 Product Manual

www.seagate.com

4.3.2 Set Features command

This command controls the implementation of various features that the drive supports. When the drive receives
this command, it sets BSY, checks the contents of the Features register, clears BSY and generates an interrupt. If
the value in the register does not represent a feature that the drive supports, the command is aborted. Power-on
default has the read look-ahead and write caching features enabled. The acceptable values for the Features
register are defined as follows:
Table 8 Set Features command
02 Enable write cache (default)
H
03 Set transfer mode (based on value in Sector Count register)
H
Sector Count register values:
00 Set PIO mode to default (PIO mode 2)
H
01 Set PIO mode to default and disable IORDY (PIO mode 2)
H
08 PIO mode 0
H
09 PIO mode 1
H
0A PIO mode 2
H
0B PIO mode 3
H
0C PIO mode 4 (default)
H
20 Multiword DMA mode 0
H
21 Multiword DMA mode 1
H
22 Multiword DMA mode 2
H
40 Ultra DMA mode 0
H
41 Ultra DMA mode 1
H
42 Ultra DMA mode 2
H
43 Ultra DMA mode 3
H
44 Ultra DMA mode 4
H
45 Ultra DMA mode 5
H
46 Ultra DMA mode 6
H
06 Enable the PUIS feature set
H
07 PUIS feature set device spin-up
H
10 Enable use of SATA features
H
55 Disable read look-ahead (read cache) feature
H
82 Disable write cache
H
86 Disable the PUIS feature set
H
90 Disable use of SATA features
H
AA Enable read look-ahead (read cache) feature (default)
H
F1 Report full capacity available
H
At power-on, or after a hardware or software reset, the default values of the features are as indicated
Note
above.
Desktop HDD SATA Product Manual, Rev. C
SATA Interface
33