Cutter Deck Belt Adjustments - Scag Power Equipment SWZU Operator's Manual

-NOTE-
When the PTO is engaged or (possibly) disen
gaged, a squealing sound from the underside of
the machine is normal. It is caused by the
electric clutch plates meshing as the mower
comes up to speed. For best equipment life,
engage the clutch with the engine at 1/2
throttle, not under full load.
WARNING:
If you are not familiar with the operation of the
hydrostatic drive and zero turn feature, practice
turning and maneuvering with the hand controls
before engaging the cutter blades.
5. Release the parking brake. Move the speed
adjustment lever to the desired mowing speed.
-NOTE-
Top speed is suggested only for transport!
6. While squeezing the steering brake levers with
both hands, release both neutral latches.
7. When the steering brake levers are released, the
machine will travel straight. To make a right turn,
squeeze the RH lever. To turn left, squeeze the
LH lever.
8. TO STOP, squeeze both levers, lock the neutral
latches, and move the speed adjustment lever to
neutral.
9. To move the machine in reverse, squeeze up on
both steering control levers.
PULL UP TO ENGAGE
PUSH DOWN TO DISENGAGE
390S0138
10. To "freewheel" or move the machine around with-
out the engine running, turn the dump valve levers
located at the back of the pumps to the "freewheel"
positions (see Figure 1). To operate the machine,
the dump valve levers must be returned to the
closed positions.
Dump Valve Levers
(normal position)
Figure 1. Dump Valves

CUTTER DECK BELT ADJUSTMENTS

All the belts on the SWZU are spring loaded
and do not require adjustment. Check the belts
for excessive wear or damage daily for the first
week. After the first week, check the belts
monthly.
1. Remove the belt covers.
2. Inspect the belts for wear, cracking, or glazing.
ire pressure can be adjusted for ire pressure can be adjusted for ire pressure can be adjusted for ire pressure can be adjusted for ire pressure can be adjusted for
Contact your Scag dealer if any unusual wear is
noted.
3. Replace the belt cover.
5
Access Right Dump Valve
From Front Of Machine
SWZU99DV
-NOTE-