Unplug Command; Init Commands; Init {Device_Id; Init {Array_Id} {Start|Stop - HighPoint RAID Management Interface Manual

HighPoint CLI Reference
This command indicates to delete the array whose id is "
the array ID before the deletion.

Unplug Command

This command allows you to remove an array or disk from a running system
without shutting down.
Syntax
unplug {array_id or device_id}
Example
HighPoint CLI> unplug 1
This command instructs the controller to disconnect the array "1" and then
you can disconnect the drives safely.

Init Commands

You can use init commands to initialize disks or arrays. A drive must be
initialized first before being used to create arrays.
Syntax

init {device_id}

init {array_id} {start|stop}

init {device_id}
This command initialize a disk for first use on the controller.
Example
HighPoint CLI> init 1/3
This command instructs the controller to initialize the disk on controller 1
channel 3. All data on the disk will be destroyed.
Init {array_id} {start|stop}
This command starts/stops initialization process on a redundant array.
Example
HighPoint CLI> init 1 stop
This command instructs the controller to stop initialization process on array 1.
You can continue the initialization at a later time.
". You can query
1
- 10 -