Keyboard Settings - Samson Carbon 49 Owner's Manual

Carbon 49 · USB/MIDI Keyboard Controller
Edit Mode
ASSIGN PEDAL
Press the ASSIGN PEDAL function key to adjust the controller number assigned to the
SUSTAIN PEDAL input. The default setting is CC #64. When pressed, the current con-
troller number will flash on the display. Rotate the DATA knob, or enter the controller
number (0–148) using the numerical keys. Refer to the MIDI Continuous Controller
(CC) List on p.18 for a list of codes and their corresponding functions. Press the ENTER
key to confirm your selection. If the number input is out of range, the display will flash
"-E-" (error) for three seconds, before returning to the last set CC number.

Keyboard Settings

RESET ALL
The RESET ALL function sets all of the Carbon 49 controller values to their defaults.
When you press the RESET ALL function key, the display will first show "No" (indicating
that you do not want to reset all functions). If you do want to reset all controllers, press
the numerical key 1, or rotate the DATA knob until "Yes" appears on the display. Press
the ENTER key to confirm, and all controllers will be reset instantly. If you press the
ENTER key while the display shows "No", the reset will be cancelled.
ALL NOTES OFF
The ALL NOTES OFF function sends an "all notes off" message in order to stop any
stuck notes. Press the ALL NOTES OFF function key and the keyboard will instantly
send the "all notes off" message, and any sustaining notes should stop.
DEFAULT
The DEFAULT function returns all of the Carbon 49 parameters to the original factory
settings. Press the DEFAULT function key, and the display will show "No" (indicating
that you do not want to reset to all default, factory settings). If you do want to reset all
controllers to their factory settings, press the numerical key 1, or rotate the DATA knob
until "Yes" appears on the display. Press the ENTER key to confirm, and all controllers
will be reset instantly. If you press the ENTER key while the display shows "No", the reset
will be cancelled.
SNAPSHOT
The SNAPSHOT function transmits all of the current controller values for the VOLUME
fader, DATA knob, PITCH BEND wheel, program number, and channel number at once,
so that you can get a full picture of your current settings. Press the SNAPSHOT key to
view these values.
17