Selecting The Recording Mode; Adjusting The S Level (Ms Stereo, 2Ch/4Ch Surround Modes); Using Ms-Raw Mode (Wav Format Only); Selecting Where Recordings Are Saved - Zoom H2next Operation Manual

Selecting the recording mode

1.
Turn so that the triangle points to the desired mode.
NOTE
∙ The 4ch surround mode can only be used
when an SD card is in the unit.
∙ In 4ch surround mode, only WAV formats
(44.1/48kHz, 16/24bit) can be used.
∙ In 4ch surround mode, two stereo files
are created (MS mic recording and XY mic
recording).
2.
Make settings for the recording mode.

Adjusting the S level (MS stereo, 2ch/4ch surround modes)

You can adjust the stereo width (S level) before recording.
•
Use to adjust the stereo width.
Wide The graphic changes along with the value
NOTE
Set to OFF , RAW or between –24 and +6 dB.
22

Using MS-RAW mode (WAV format only)

If you want to adjust the stereo width after recording, record using MS-RAW
mode.
•
Hold

Selecting where recordings are saved

1.
Press .
2.
Use
press
3.
Use
to save fi les, and then press
Narrow
NOTE
Select from among 10 folders. There are separate sets of folders for stereo and 4ch recordings.
H2n
down until RAW appears.
to select FOLDER, and then
.
to select the folder where you want
.
Handy Recorder
23