How To Connect The Inlet Hose - Daewoo DWF-200TATC Service Manual

§• §•

How to Connect the Inlet Hose

Be careful not to mistake in supplying between the hot(maximum : 50˚C) and cold water.
In using only one water tap or in case of attached one water inlet valve, connect the inlet hose to the cold water inlet
valve.
Do not over tighten : this could cause damage to couplings.
FOR ORDINARY TAP
1
Pull down the collar
of the inlet hose to
separate it from the
water tap adapter.
4
Remove the tape,
and screw connector
B into connector A
tightly.
Connector A
Connector B
FOR SCREW-SHAPED TAP
1
Connect the inlet
hose to the water tap
by screwing the
connector D tightly.
Rubber
Packing
Connector D
Inlet Hose Connector C
2
Loosen the four
screws at the water
tap adapter, but don't
loosen the screws until
they are separated from
the water tap adapter.
5
Connect the inlet
hose to the water tap
adapter by pulling down
the collar of the hose end.
2
Connect the
connector-inlet
supplied if necessary.
Connector
Inlet
Rubber
Packing
Connector D
Hose
Connector C
3
Connect the water tap
adapter to the water tap and
tighten the four screws evenly
with pushing up the adapter
so that the rubber packing
can stick to the water tap
tightly.
6
Connect the inlet hose adapter
to the water inlet of the washer
by turning it clockwise to be
fixed tightly.
• Please check the rubber packing
inside the inlet hose adapter.
3
Insert the inlet hose adapter
into the water inlet of a washer
and turn it to be fixed.
• Check the packing in the inlet
CONNECTION
TAPE
5