Activate Your Device - Kyocera Virgin Rise User Manual


Insert the battery, contacts end first, and gently press into place (

Make sure the locking tabs of the cover are seated and then gently press the cover.
( ).
2. Charge your battery.
 Plug the smaller end of the micro-USB cable into the device's charger/accessory jack.

Plug the other end of the USB cable into the charger, and then plug the charger into
an electrical outlet.
WARNING: Do not handle a damaged or leaking Li-Ion battery as you can be burned.
Note: Your device's battery should have enough charge for the device to turn on and find a
signal, run the setup application, set up voicemail, and make a call. You should fully
charge the battery as soon as possible.
3. Press and hold the Power button to turn your device on.
To remove the battery, after removing the battery compartment cover, grasp the tab extending
from the battery pack and pull the battery out of its compartment.

Activate Your Device

Find out information about activating your device.
Get Started 3
).