Know Your Compound Miter Saw; Miter Lock Handle - Ryobi TS1342 Operator's Manual

KNOW YOUR COMPOUND MITER SAW

See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
15 AMP MOTOR
The saw has a powerful 15 amp motor with sufficient power
to handle tough cutting jobs. It is made with all ball
bearings, and has externally accessible brushes for ease
of servicing.
10 in. BLADE
A 10 in. blade is included with the compound miter saw. It
will cut materials up to 2 in. thick or 6 in. wide, depending
upon the angle at which the cut is being made.
BLADE WRENCH STORAGE
See Figure 1.
A blade wrench is packed with the saw. One end of the
wrench is a phillips screwdriver and the other end is a hex
key. Use the hex key end when installing or removing blade
and the phillips end when removing or loosening screws.
A storage area for the blade wrench is located in the saw's
base.
CARRYING HANDLE
See Figure 2.
For convenience when carrying or transporting the miter
saw from one place to another, a carrying handle has been
provided on top of the saw arm. To transport, turn off and
unplug the saw, then lower the saw arm and lock it in the
down position. Lock saw arm by depressing the lock pin.

MITER LOCK HANDLE

See Figure 2.
The miter lock handle securely locks the saw at desired
miter angles.
SPINDLE LOCK BUTTON
See Figure 3.
The spindle lock button locks the spindle stopping the blade
from rotating. Depress and hold the lock button while install-
ing, changing, or removing blade.
SWITCH TRIGGER
See Figure 4.
To prevent unauthorized use of the compound miter saw,
disconnect it from the power supply and lock the switch
in the off position. To lock the switch, install a padlock (not
included) through the hole in the switch trigger. A lock with
a long shackle up to 9/32 in. diameter may be used. When
the lock is installed and locked, the switch is inoperable.
Store the padlock key in another location.
FEATURES
SAW
ARM
SAW ARM LOCKED IN DOWN POSITION
SWITCH
TRIGGER
SWITCH
TRIGGER
11
CARRYING
HANDLE
MITER LOCK
HANDLE
LOCK
PIN
Fig. 2
SPINDLE
LOCK BUTTON
Fig. 3
PADLOCK
Fig. 4