Installation; Remote Control; Notes On Batteries; Notes On Remote Control Operation - Runco PlasmaWall PL-50XA Owner's Operating Manual

Flat panel plasma display monitor with widevision and digital high definitiontm controller with vivix ii technology

Hide thumbs Also See for PlasmaWall PL-50XA:

Table of Contents

To install batteries in the remote control:

1. Press down the tab on the cover and

pull the cover in the direction of the

arrow.

2. Insert the included batteries. Ensure

that the polarities correctly match the

and

markings inside the battery

compartment.

3. Insert the lower tab of the cover into the

opening, and press down the cover until

it clicks in place.

• When installing batteries, make sure that the battery polarities are correct.

• Do not mix an old battery with a new one or different types of batteries.

• If you will not use the remote control for a long time, remove the batteries to avoid

damage from battery leakage.

The remote control can be used to control the PlasmaWall within the ranges shown in

Figure 3-1.

Approx.

7m /23ft

Figure 3-1. Available Range of the Remote Control

Runco PlasmaWall Owner's Operating Manual

3. Installation

3.1

Notes on Remote Control

Operation

Table of Contents