Installation; Remote Control; Notes On Batteries; Notes On Remote Control Operation - Runco PLASMAWALL XP-50DHD Installation And Operation Manual

To install batteries in the remote control:
1. Press down the tab on the cover and
pull the cover in the direction of the
arrow.
2. Insert the included batteries. Ensure
that the polarities correctly match the
and markings inside the battery
compartment.
3. Insert the lower tab of the cover into the
opening, and press down the cover until
it clicks in place.
• When installing batteries, make sure that the battery polarities are correct.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
The remote control can be used to control the PlasmaWall within the ranges shown in
Figure 3-1.
3
16:9
Approx. Approx.
30º 30º
RETURN
EXIT
16 : 9
4 : 3
HDMI HDMI
1 2
CUST CUST
SVC
1 2
Figure 3-1. Available Range of the Remote Control
PlasmaWall XP Series Installation/Operation Manual
standby
HDMI 1
m
e
n
1080i/60 u
Approx.
40 feet
(12.2 meters)
15

3. Installation

3.1

Remote Control

Notes on Batteries

Notes on Remote Control
Operation