Sewing On Buttons - Janome OC 6125 Instruction Book

1
2
3
2
4
22
4
5
6
1
5
3

Sewing on Buttons

Machine setting
1.
Pattern #3
2.
Foot F: Satin stitch foot
3.
Thread tension Auto
4.
Stitch width Adjust as necessary
5.
Stitch length Any (not necessary to adjust)
6.
Feed dog Dropped
1. Unthread the needle. Adjust the stitch width to
match the needle swing with the span of the holes
on the button, by turning the handwheel.
2. Rethread the needle and lower the presser foot to
hold the button in place.
A pin can be placed on top of the foot to from a
shank.
3. Turn the handwheel toward you to check if the
needle enters both left and right holes of button.
4. Depress the foot control to sew 10 stitches and
stop the machine.
5. Raise the foot and draw out the fabric, and cut the
threads leaving 20 cm (8˝) tails.
NOTE: Trim both needle and bobbin threads at the
beginning of stitches.
6. Draw the needle thread through the hole on the
button to bring it between the button and fabric.
Pull the needle thread to pick the bobbin thread up
to the right side of the fabric. Wind the threads in
opposite directions around the thread shank a few
times and tie them together.
NOTE: After finish sewing, raise the feed dog by
shifting the drop feed lever to the original
position.
1.
Pin
2.
Needle thread
3.
Bobbin thread
4.
Fabric
5.
Shank