Troubleshooting - iHome iD50 Instruction Manual

Symptom
Unit does not turn on AC adaptor isn't plugged into a working wall
socket or not plugged into the power supply
jack on back of the unit
Unit doesn't respond
Unit requires a reset
iPhone/iPod is not docked properly
Battery Low icon Battery is weak
always flashing
Battery was not installed properly
iPhone/iPod does not iPhone/iPod is not docked properly
respond to the unit/iPod
is playing but no sound
comes out
Your iPhone/iPod software is too old
iPhone/iPod is locked up/plays but no sound
comes out
Using 1
other devices.
Unit/iPhone/iPod The unit is reacting to external interference
performance is erratic
No sound from unit Volume is set too low on unit
iPad/iPhone/iPod is not docked properly
iPhone/iPod didn't
charge up
iPhone/iPod is locked up/ frozen
iPhone/iPod battery has problem
No AM band radio AM loop antenna is not connected to the unit
sound but others OK
AM band radio is very AM loop antenna isn't located properly
noisy
Time sync didn't work Older iPod models such as iPod mini do not
support time sync function

Troubleshooting

Possible Problem
st nd
or 2 generation iPod, iPod Shuffle or
Plug the AC adaptor into a working wall socket and plug the connector
into the supply jack on the unit
If unit is plugged in and doesn't respond, try resetting the unit by
following these steps:
a) remove iPhone/iPod from dock
b) unplug unit from power source
c) remove back up battery
d) wait a few minutes, then restore battery and resume use
Remove your iPhone/iPod from the dock and check for obstruction on
the connectors in the dock and on your iPhone/iPod. Then reseat it in
the dock.
Replace with new battery
Check to make sure the + side is facing outwards
Remove your iPhone/iPod from the dock and check for obstruction on
the connectors in the dock and on your iPhone/iPod. Then reseat it in
the dock.
Upgrade software on your iPhone/iPod via iTunes on your computer
Check the volume setting. Make sure your iPhone/iPod is working
properly before docking into the unit. Please refer to your
iPhone/iPod manual for details. See above for software upgrade
information.
You may need to reset your iPhone/iPod. Refer to your iPhone
or iPod user guide for details on how to perform a reset.
Unit cannot control those iPod models or other devices.
Move unit away from potential sources of external interference such as
computers, modems, wireless devices (routers) or fluorescent light.
Make sure volume is turned up
Remove your iPhone/iPod from the dock and check for obstruction on
the connectors in the dock and on your iPhone/iPod. Then reseat it in
the dock.
Please make sure your iPhone/iPod is working properly before docking
into the unit. Please refer to your iPhone/iPod manual for details.
Plug the AM loop antenna connector to the jack on the back of the unit
Move the AM loop antenna away from the main unit AC adaptor and
rotate it for best reception
Make sure you are using an iPhone or newer iPod such as touch,
nano or classic. If not available, set time manually (see page 5).
12
Solution