Hunter 44110 Installation And Operation Manual page 41

2. Span setting mode – allows you to adjust the system ON/OFF
cycle rate. The default setting is 2 (the system cycles ON or
OFF when the temperature is within 1
below the set temperature). The span setting can be adjusted
if your system is cycling too fast or too slowly.
Press and hold both the
SPAN appears. Use the
setting.
(Up will increase your cycle time by allowing the system to run longer;
down will decrease your cycle time by causing the system to run for a
shorter length of time.)
Span settings remain the same for
settings. When batteries are installed, or the unit is
span cycle will revert to 2.
icons anD features, cont.
Up
Up
o
F (0.5
and buttons until the word
Down
or button to adjust the span
Down
and
HEAT
41
o
C) above and
system
COOL
, the
RESET