Hunter 44110 Installation And Operation Manual page 11

uninstalling the existing unit, cont.
4. Using the provided stickers, label each wire according to the
Common wire and should not be used. If you have a wire marked
C, do not connect it to any terminal. This wire is used only for non-
battery powered thermostats.
5. Do not let the wires slip back into the wall during
disconnection. You may want to secure the wires to the
wall as you disconnect them. After all wires are labeled,
disconnect each wire and remove the existing wall plate.
unused wires should be capped with an approved electrical connector, such
as electrical tape.)
chart.
(If the terminals are not labeled, contact a qualified HVAC
technician.)
note: Wire colors do not always comply with
standards, so wire color should be ignored. refer
to the existing terminal designation for proper
identification.
*If wires marked Y & C are both present, C may be a
11
(Any