Connecting The Wires - Hunter 44110 Installation And Operation Manual

installing the thermostat, cont.
1. Loosen, but do not remove, the terminal screws.
Jumper
G RC RH Y W
2. Match and connect the wires from the wall to the terminals
as shown. Wires should be inserted behind the black terminal
shields. Tighten each screw after the connection has been
made.
(the ends of any extra wires should be individually wrapped in
electrical tape and carefully pushed back into the wall.)
3. Push any excess wire length back into the wall to prevent
interference.
note: a jumper wire has been provided, connecting
the rc and rh terminals for systems that do not
provide both an rh and rc wire. if you have both an
rh and rc wire, remove this jumper. if you do not
have both an rh and rc wire, leave the jumper in
place.

CONNECTING THE WIRES

17