Ricoh VT2250 Operator's Manual page 138

When one of the following messages is displayed on the
guidance display:
Guidance Display
RE-ENTER COPY NUMBER
MAXIMUM IS XXXX
RE-ENTER COPY NUMBER
MINIMUM IS XXXX
SET THE ORIGINAL
INPUT YOUR ID CODE
NO ADDITIONAL PRINTS
ALLOWED
MASTER MAKING HALTED
PRESS RESET KEY
When a service code (E-XX) is displayed in the counter
Turn the main switch off and on. If a service code appears again, contact
your service representative.
NOTE: If a service code appears on the counter after you turn the main
switch off and on a few times, do not continue turning it on and off.
Leave the machine off.
Meaning and action
The maximum number of prints that can be
entered is specified by the Service Program
mode. Change the number of prints.
The minimum number of prints that can be
entered is specified by the Service Program
mode. Change the number of prints.
Make prints after you confirm whether there is an
original or a command sheet on the exposure
glass.
User Code mode is set. Before printing, enter
your user code.
Security mode is set. If you make the next
master, Security mode is canceled.
Master making is halted. Press the Reset key.
TROUBLESHOOTING
130