Ricoh DDP92 Maintenance Manual page 142

6. Fit the two pegs on the jig into the corresponding holes in the clincher.
Figure 6-77. Adjustment of the Stapler Vertical Positioning
7. Rotate the stapler gears downward. Adjust the clincher position so that the plate
on the cartridge fits smoothly into the groove on the jig.
8. With the plate in the groove, tighten the 4 clincher set screws to fasten the
clincher into place.
9. Rotate the stapler gears back upwards, and remove the jig.
10. Remove the plate from the cartridge and set it back into the jig.
11. Reinstall the cartridge and check that stapling operates correctly.
Figure 6-78. Adjustment of the Stapler Vertical Positioning
M M L 0 0
Disassembling, Assembling & Adjustment
6-53