Removal Of The Rubber, Double Feed Prevention Roller - Ricoh DDP92 Maintenance Manual

6.2.10. Removal of the Rubber, Double Feed Prevention Roller

CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.
Applicable jigs and tools: +Screwdriver.
[Disassembling Procedures]
1. Remove the cover A.
2. Remove the feed roller unit.
3. Remove the 4 set screws, Then remove the plate.
4. Remove the 3 stop rings, then pull out the shaft, and remove the double-feed-pre-
5. Remove the rubber from the double-feed-prevention roller.
Figure 6-49. Removal of the Rubber, Double Feed Prevention Roller
[Assembling Procedures]
1. Reinstall the Rubber, Double Feed Prevention Roller reversing the procedure
CAUTION:
Ensure that the mounting direction of the rubber is correct.
(Refer to item 6.2.8 on page 6-27)
vention roller together with the feed-reverse gear.
above.
M M L 0 0
(Refer to item 6.2.9 on page 6-28)
Disassembling, Assembling & Adjustment
6-29