Advertisement
5. Insert the small end of the copper tube into the plastic tube
(the end without the black connector). (Fig. 5)
Figure 5
PLATFORM
PLASTIC
TUBE
BLACK
CONNECTOR
6. Insert the end of the plastic tube with the black connector into the pump.
(Fig. 6)
Figure 6
PLATFORM
PLASTIC
TUBE
BLACK
CONNECTOR
7. Then place the platform on the base so it sits level. Lead the cord out
through the cord slot located on the upper backside of the base. (Fig 7.)
8. Slide the U-shaped clips over the copper bar, one on either side of the
vertical pole. (Fig. 8)
Figure 7
COPPER TUBE
PLATFORM
CORD
CORD
SLOT
6
SMALL END OF
COPPER TUBE
SMALL END OF
COPPER TUBE
PUMP
BASE
Figure 8
U-SHAPED
CLIPS
VERTICAL POLE
SLATE WALL
9. Hold the slate wall in between the U-shaped clips, aligning the holes.
Then, slide the long screws through the holes. Secure with the corre-
sponding nuts on the back. (Fig. 9)
Figure 9
NUT
SLATE WALL
10. Fill the base with clean water until the water level is 3/4" below the
lowest edge of the base. (Fig. 10)
11. Attach the A/C adaptor jack to the base power cord. (Fig. 1)
Figure 10
12. Plug the cord into 120V household outlet. The fountain is controlled by
a switch located on the power cord. If pump does not operate, rotate
in-line switch once to turn "on" and once to turn "off".
Note: Ensure that the electrical cord loops below the electrical outlet to
form a "Drip Loop". This will prevent water from running down the
electrical cord into the electrical outlet. (Fig. 11)
7
U-SHAPED
CLIPS
LONG
SCREWS
Advertisement
