Advertisement
Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth. (Fig 1)
NUT
Figure 1
LONG
SCREW
SHORT
SCREW
PLATFORM
NUT
PLASTIC TUBE
CONNECTOR
PUMP
BASE
2. Familiarize yourself with the pump. The pump speed is controlled by
the switch located at the front of the pump. The speed is indicated by
a plus (+) and minus (-) sign. To increase the speed, move the switch
slowly downward in the direction of the plus sign. You will hear a click
as the switch moves to each speed level. At its highest speed level,
the switch will cease to move any further. To decrease the pump
speed, move the switch upward toward the minus sign. Similarly, at its
lowest speed, the switch will cease to move any further (Fig 2).
NOTE: It is recommended the pump be set at its highest speed dur-
ing assembly and later adjusted to a lower setting if desired. Be sure
to unplug the pump before adjusting the speed setting.
4
U-SHAPED
CLIPS
LONG
SCREW
SLATE WALL
SHORT
SCREW
SMALL END OF
COPPER TUBE
LIGHT HOLE
CENTER HOLE
WATERPROOF LIGHT
SWITCH
SWITCH
AC ADAPTOR
Figure 2
Attention:
In order to get
best results,
please operate
pump completely
submerged.
Keep the water
level above the
minimum water
level ALL THE
TIME.
3. Insert the small end of the copper tube through the center hole of the plat-
form and secure with the short screws and corresponding nuts. (Fig. 3)
Figure 3
SHORT
SCREW
4. Insert the waterproof light into the light hole located under the platform. (Fig.
4) Be sure to push far enough so "rubber neck" is secure in the light hole.
Slight twisting may help to push the rubber neck through the hole more -
easily. Note: Be gentle with the bulb cover since it is made of glass.
Figure 4
PLATFORM
Minimum Water Level
Flow Control Valve
(+) faster water
output
(-) slower water
output
SHORT
SCREW
SMALL END OF
COPPER TUBE
LIGHT HOLE
CENTER HOLE
LIGHT HOLE
WATERPROOF
LIGHT
5
Advertisement
