Honda Accord Crosstour Owner's Manual page 388

If you do not find an obvious leak,
6.
check the coolant level in the
radiator reserve tank (see page
288 ). Add coolant if the level is
below the MIN mark.
If there was no coolant in the
7.
reserve tank, you may need to add
coolant to the radiator. Let the
engine cool down until the pointer
reaches the middle of the tempera-
ture gauge, or lower, before check-
ing the radiator.
Removing the radiator cap
while the engine is hot can
cause the coolant to spray out,
seriously scalding you.
Always let the engine and
radiator cool down before
removing the radiator cap.
Using gloves or a large heavy
8.
cloth, turn the radiator cap
counterclockwise, without pushing
down, to the first stop. After the
pressure releases, push down on
the cap, and turn it until it
comes off.
9. Start the engine, and set the
temperature to maximum heat
(climate control to AUTO at
'' ''). Add coolant to the
radiator up to the base of the filler
neck. If you do not have the
proper coolant mixture available,
you can add plain water.
Remember to have the cooling
system drained and refilled with
the proper mixture as soon as
you can.
2011 Accord Crosstour
If the Engine Overheats
Put the radiator cap back on
10.
tightly. Run the engine, and check
the temperature gauge. If it goes
back to the red mark, the engine
needs repair (see
Emergency
Towing on page 397 ).
11. If the temperature stays normal,
check the coolant level in the
radiator reserve tank. If it has
gone down, add coolant to the
MAX mark. Put the cap back
on tightly.
385