Honda Accord Crosstour Owner's Manual page 355

Lights
HOLDING CLIP
SCREW
Driver's side
4. To change the bulb, start the
engine, turn the steering wheel all
the way to the right, then turn off
the engine.
5. Use a flat-tip screwdriver to
remove the holding clip from the
inner fender, and remove the
screw with a Phillips-head
screwdriver.
352
BULB
ELECTRICAL CONNECTOR
6. Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
7. Remove the bulb from the fog
light assembly by turning it one-
quarter turn counterclockwise.
Driver's and Passenger's side
8. Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
2011 Accord Crosstour
9. Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
10. Turn on the fog lights to test the
new bulb.
11. Passenger's side
Reinstall the under cover and
holding clips, and then push in the
head of each clip.
TAB
Driver's side
Put the inner fender cover in place.
Install the holding clip. Lock it in
place by pushing on the center.
Tighten the screw securely.