Heat Controller VMH 09 Installation Manual page 9

Heat Controller, Inc.
4. Indoor unit installation
1. Pass the piping through the hole in the wall.
2. Put the upper claw at the back of the indoor
unit on the upper hook of the installation
plate, move the indoor unit from side to
side to see that it is securely fastened (see
Fig.12).
3. Separate the bottom of the indoor unit from
the wall by inserting spacer, etc., between
the indoor unit and the wall. Remove spacer
after piping is complete.
4. Push the lower part of the indoor unit up on
the wall, then move the indoor unit from side
to side, up and down to check if it is secure.
INSTALLATION MANUAL
8
VMH InverterFlex Mini-Split
Spacer