Grandstream Networks GXP2124 User Manual page 56

Static IPv6 Address
IPv6 Prefix Length
IPv6 Prefix
DNS Server 1
DNS Server 2
Preferred DNS server
Network -> Advanced Settings
802.1X mode
802.1X Identity
MD5 Password
802.1X CA Certificate
802.1X Client Certificate
HTTP Proxy
HTTPS Proxy
Layer 3 QoS
Layer 2 QoS 802.1Q/VLAN
Tag
Layer 2 QoS 802.1p Priority
Value
PC Port Mode
Enable LLDP
FIRMWARE VERSION 1.0.5.24
Enter the static IPv6 address when Full Static is used in "Statically
configured" IPv6 address type.
Enter the IPv6 prefix length when Full Static is used in "Statically
configured" IPv6 address type.
Enter the IPv6 Prefix (64 bits) when Prefix Static is used in "Statically
configured" IPv6 address type.
Enter the DNS Server 1 for IPv6.
Enter the DNS Server 2 for IPv6.
Enter the Preferred DNS Server for IPv6.
Allows the user to enable/disable 802.1X mode on the phone. The
default value is disabled. To enable 802.1X mode, this field should be set
to EAP-MD5.
Enter the Identity for the 802.1X mode.
Enter the MD5 Password for the 802.1X mode.
Upload 802.1X CA certificate to the phone; or delete existed 802.1X CA
certificate from the phone.
Upload 802.1X Client certificate to the phone; or delete existed 802.1X
Client certificate from the phone.
Specifies the HTTP proxy URL for the phone to send packets to. The
proxy server will act as an intermediary to route the packets to the
destination.
Specifies the HTTPS proxy URL for the phone to send packets to. The
proxy server will act as an intermediary to route the packets to the
destination.
Defines the Layer 3 QoS parameter. This value is used for IP
Precedence, Diff-Serv or MPLS. The default value is 12.
Assigns the VLAN Tag of the Layer 2 QoS packets. The default value is
0.
Assigns the priority value of the Layer2 QoS packets. The default value is
0.
Configures the PC port mode. When set to "Mirrored", the traffic in the
LAN port will go through PC port as well and packets can be captured by
connecting a PC to the PC port. The default setting is "Enable".
Control the LLDP(Link Layer Discover Protocol) service.
GXP2124 USER MANUAL Page 56 of 71