Storing A Measurement; Recalling A Measurement - Fluke 1652C User Manual

1652C/1653B/1654B
Users Manual
2. To enable the data subset number to be changed, press . The data
subset number will now be flashing. To enable the data sub number to be
changed, press  again. The data set number will now be flashing. Press
 again to change the data id number.
3. Press the down arrow key () to decrement the enabled number or press
the up arrow key () to increment the enabled number. For storing data,
the number can be set to any value, overwriting existing data is allowed.
For recalling data, the number can only be set to used values.
If you press the up or down arrow key () once, the number
increments or decrements by one. To accelerate the increment or
decrement function, press and hold the up or down arrow.

Storing a Measurement

To store a measurement:
1. Press  to enter Memory mode.
2. Press  and use the arrow keys () to set the data identity.
3. Press  to save the data.
If memory is full, FULL will appear on the primary display. Press  to
choose another data identity, press  to exit Memory mode.
If the memory is not full, the data will be saved, the tester will
automatically exit Memory mode and the display will revert back to the
previous test mode.
If the data identity has been previously used, the display will show
STO? Press  again to store the data, press  to choose another
data identity, press  to exit Memory mode.
Extended documentation mode:
For insulation and continuity tests, you can store additional information with the
measurement result. For more information, see "Measuring Insulation
Resistance" and "Measuring Continuity".

Recalling a Measurement

To recall a measurement:
1. Press  to enter the Memory mode.
2. Press  to enter the Recall mode.
3. Use  and the arrow keys () to set the data identity. If no data has been
saved, all fields will be dashes.
38
Note