To Connect The Hose To The Cylinder - Weber Summit S-670 Owner's Manual

TO CONNECT THE HOSE TO THE CYLINDER:
1 )
Locatehoseretention
clip
(a)
on regulator
hose.Securehlto slot
(b) on
underside
oftank scale.
Ak WARNING: The hose must be secured to the tank scale
with the Hose Retention Clip. Failure to do so could cause
damage to the hose resulting in a fire or explosion which
can cause serious bodily injury or death, and damage to
property.
Some LP tanks have differing top collar assembles. (The top collar is the metal
protective ring around the valve. 5 One series of tanks mount with the valve facing
front (a 5. The other tanks mount with the valve facing away from the fuel scale
(b). Weber recommends the use of cylinder manufacturer's Manchester and
Worthington, with a 47.6 Ib wafer capacity. Other cylinders may be acceptable for
use with the appliance provided they are compatible with the appliance retention
means (see illustrations).
The LP cylinder is installed inside the base cabinet, on the tank
scale (right side).
2) Open base cabinet doors.
3) Turn the LP cylinder so the opening of the valve is either to
the front, side or rear of the Webel e gas barbecue. Lift and
hook the cylinder onto the fuel gauge.
4) Lift tank up into position on the tank scale.
5) Loosen the cylinder lock wing nut. Swing the cylinder lock
down. Tighten the wing nut.
TO CONNECT THE HOSE TO THE CYLINDER:
6) Remove the plastic dust cover from the valve.
7) Screw the regulator coupling onto the tank valve, clockwise,
or to the right. Hand-tighten only.
Note: This connection tightens clockwise and will not allow gas
to flow unless tfte connection is tighL The connection requires
tightening by hand only
A,, WARNING: Do not use a wrench to tighten
the connection. Using a wrench could
damage the regulator coupling and could
cause a leak.
You will need: LP cylinder, a soap and water solution and a rag or
brush to apply it.
85 Mix soap and water.
95 Turn on the cylinder valve.
105 Check for leaks by wetting the fitting with the soap and water
solution and watching for bubbles. If bubbles form, or if a
bubble grows, there is a leak.
If there is a leak, turn off the gas and tighten the fitting.
Turn the gas back on and recheck with the soap and water
solution.
If leak does not stop do not use the barbecue. Contact the
custonler service representative in your area using the
contact information on our web site. Log onto t_'.weher.
COme.
11 ) When leak checking is complete, turn gas supply off at the
source and rinse connections with water.
©
I |'J_&'J_&'J_A'_J =1:1 =l:ll[l(I] :_ _