Prepare To Connect The Lp Cylinder - Weber GENESIS E-330 Owner's Manual

PREPARE TO CONNECT THE LP CYLINDER

The regulator must be secured to the side panel with the supplied hose retention
bracket.
Installation Inside of Cabinet
A) Open base cabinet doors.
B) Slide hose retention bracket (1) along hose to align with inside right panel front
mounting holes. Secure with two Phillips head screws/washers/bolts (2).
m WARNING: The hose must be secured to the side panel with the
hose retention bracket. Failure to do so could cause damage
to the hose resulting in a fire or explosion, which can cause
serious bodily injury or death, and damage to property.
Note: Be sure the cylinder brackets are installed in the base panel and the base of the
cylinder fits within the cylinder brackets.
Installation Outside of Cabinet
A) Open base cabinet doors.
B) Pass the regulator hose and hose retention bracket (1) out through the side panel
opening.
C) Align with side panel mounting holes located beneath the side panel opening.
Secure with two Phillips head screws/washers/bolts (2).
m WARNING: The hose must be secured to the side panel with the
hose retention bracket. Failure to do so could cause damage
to the hose resulting in a fire or explosion, which can cause
serious bodily injury or death, and damage to property.
GAS INSTRUCTIONS
1
◆
2
1
2
WWW.WEBER.COM 11