Table of Contents
Advertisement
Attaching ChuteDirectional Control
•
Remove the hairpin clip from the upper chute crank
and slide the upper chute crank through the bracket
and into the lower chute crank. See Figure 4.
•
Align the two holes on both chute cranks and insert
the hairpin clip removed earlier, through these
holes. See Figure 4.
Upper Chute Crank
Figure 4
Routing ChuteTilt Cables
•
If not already routed, slip the cables that run from
beneath the handle panel to the discharge chute
through the cable guide located on top of the
engine housing. See Figure 5.
Connecting A lternator Lead
(Model 8526 Only)
•
Unwrap the headlight wire which is attached to the
headlights, beneath the handle panel. Wind the
wire around the lower right handle until excess
slack is removed. See Figure 6.
Discharge Chute
Cable Guide
Figure 5
III
I
-Alternator
Lead
Right Handle
Lamp Wire
Figure 6
Plug the wire from the headlight into the alternator
lead located on the right side of the engine,
beneath the fuel tank. See Figure 6.
SECTION 3: KNOW YOUR SNOW THROWER
_lb
WARNING:
Read, understand,
and follow
all instructions and warnings on the machine
and in this manual before operating.
ChuteTilt Control
The distance snow is thrown can be changed by
adjusting the angle of the chute assembly. Move the
chute tilt control forward to decrease the distance,
toward the rear to increase. See Figure 7.
DischargeChute
The angle of the discharge chute controls the distance
that the snow is thrown. Tilt the discharge chute up for
greater distance; tilt down for less distance.
Skid Shoes
The space between the shave plate and the ground can
be adjusted by positioning the skid shoes. Refer to Skid
Shoe Adjustment on page 12.
Throttle Control
The throttle control is located on the engine. It regulates
the speed of the engine. See Figure 7.
Safety IgnitionKey
The ignition key must be inserted in the switch in order
for the engine to start. Remove the ignition key when
the snow thrower is not in use.
NOTE:
Do NOT "turn" the ignition key in an attempt to
start the engine.
Advertisement
Table of Contents
