Carburetor Adjustment - Troy-Bilt TB25ET Operator's Manual

CARBURETOR ADJUSTMENT
The idle speed of the engine is adjustable through the air
filter/muffler cover (Fig. 41).
NOTE: Careless adjustments can seriously damage your
unit. An authorized service dealer should make
carburetor adjustments.
Check Fuel Mixture
Old and/or improperly mixed fuel is usually the reason
for improper unit performance, Drain and refill the tank
with flesh properly-mixed fuel pnor to making any
adjustments. Refer to Oil and Fuel Information.
Clean Air Filter
The condition of the air filter is important to the operatton
of the unit. A dirty air filter will restrict air flow and
change the air/fuel mixture. This is often mistaken for an
out of adJustment carburetor. Check the condition of the
air filter before adjusttng the idle speed screw. Refer to
Air Filter Maintenance.
Adjust Idle Speed Screw
If. after checking the fuel mixture and cleaning the air
filter, the engine still will not idle. adjust the idle speed
screw as follows:
1. Start the engine and let _trun at a h_gh idle for a
m_nute to warm up. Refer to Starting/Stopping
Instructions.
sp_nning during idle speed adjustments. Wear
protective clothing and observe all safety
instructions to prevent serious personal injury.
2. Release the throttle trigger and let the engine idle. If
the engine stops, insert a small phillips or flat blade
screwdriver into the hole in the air filter/muffler cover
(Fig. 41). Turn the idle speed screw in, clockwise,
1/8 of a turn at a time (as needed) until the engine
idles smoothly.
\
!
Idle Speed Screw
Fig. 41
NOTE: The cutting attachment should not rotate when
the engine idles.
3. If the cutting attachment rotates when the engine idles,
turn the idle speed screw counterclockwise 1/8 of a
turn at a time (as needed), to reduce idle speed.
Checking the fuel mixture, cleaning the air filter, and
adjusting the idle speed should solve most engine
problems.
If not and all of the following are true:
• The engine will not idle
• The engine hesitates or stalls on acceleration
• There is a loss of engine power
Have the carburetor adjusted by an authorized service
dealer.
WARNING: When the unit is turned off, make I
sure the Cutting attachment has Stopped I
before the unit is set down. This will help to
prevent serous persona njury,
j
19