Sony Handycam DCR-DVD200 Operating Instructions Manual page 115

Changing the SETUP display
Icon/item Option Meaning Mode dial
OTHERS
•
REMAIN • AUTO
To display the remaining capacity of the disc in I_ Movie
the following cases for example: I_1 Still
• For 8 seconds after setting the power on and [] Play/Edit
the mode dial to I_ (Movie) or I_1 (Still)
• For 8 seconds after recognizing the inserted
disc into your camcorder in II_ (Movie) or I_1
(Still)
• For 8 seconds when set the display to on by
pressing DISPLAY/BATT INFO in D (Movie)
or I_1 (Still)
• When the remaining capacity of the disc is less
than 5 minutes in II_ (Movie) or 20 in I_1 (Still)
• For 8 seconds when starting recording from
the line input
ON
To always display the remaining capacity of
the disc
Notes
• If you press DISPLAY/BATT INFO with [DISPLAY] set to [V-OUT/LCD] in the SETUP display,
the picture fi'om a TV or VCR will not appear on the LCD display even when your camcorder is
connected to outputs on the TV or VCR.
• If more than five minutes passes after removing the power source, the [PROGRAM AEI, [FLASH
LVLI, [WHT BALI, [COMMANDER], and [HiFi SOUND] settings are returned to their factory
settings. Other settings are held in memory even when the battery is removed.
Tip
When recording a close subject, if [RECLAMP] is set to [ON[, the red camera recording tamp on
the fi'ont of the camcorder may reflect on the subject if it is close. In this case, it is recommended to
set [REC LAMP] to [OFF[.
8"
_3
__..
g
o
o
2.
115