Control Functions - Snapper S50XBS2648 Operator's Manual

Features sndControls
Figure 2. Control Locations
ControlFunctions
Theinformation below briefly describes the function of individual controls. Starting, stopping, driving, and mowing require
the combined use of several controls appfied in specific sequences. Tolearn what combination and sequence of controls to
use for various tasks see the OPERATION section.
GroundSpeed Control Levers
These levers control the ground speed of the rider. The left
lever controls the left rear drive wheel and the right lever
controls the right rear drive wheel.
Moving a lever forward increasesthe FORWARDspeed of
the associated wheel, and pulling back on a lever increases
the REVERSE speed.
Note: Thefurther a lever is moved away from the neutral
position the faster the drive wheel will turn.
See the Operationsection for proper steering instructions.
Seat Adjustment Lever
The seat can be adjusted forward and back. Move the lever
towards the left, position the seat as desired, and releasethe
lever to lock the seat in position.
IgnitionSwitch
The ignition switch starts and stops the engine, it has three
positions:
_OFF Stops the engine and shuts off the
electrical system.
O RUN Allows the to and
engine
run
powers
the electrical system.
_'_ START Cranks the engine for starting.
NOTE.Never leave the ignition switch in the RUN position
with the engine stopped-this drains the battery.
11