Table of Contents
Advertisement
Section 3 - OPERATING
INSTRUCTIONS
3.3 CUTTING HEIGHT ADJUSTMENT
1. Adjust cutting height, as desired, to any position,
using deck lift lever. The release latch should be
pulled up when lowering the deck. When raising the
deck, the release latch does not have to be pulled
up. IMPORTANT:
There
is a foot
assist
pedal
located to the right front side of the footrest. Always
use this assist pedal to raise or lower the deck to the
desired cutting height. See Figure 3.9 & 3.10.
2. If a specific deck height is desired each time the
machine
is used, insert the stop pin to desired
cutting height. See Figure 3.11.
NOTE: The engine does not have to be running to adjust
cutting height.
DECK LIFT
LEVER SHOWN IN
HIGH CUTTING
HEIGHT
FIGURE 3.11
6 HOLE POSITIONS
FOR STOP PIN
PULL RELEASE
LATCH UP WHEN
CHANGING
THE
DECK HEIGHT
FIGURE 3.9
3.4 OPERATION- MOTION CONTROLS
3,4.1,
DRIVING MACHINE
1. Start engine. Release parking brake.
2. Move
motion
control
lever
gently
and
with
caution in desired direction.
FORWARD - Move control lever forward.
REVERSE - Move control lever rearward.
LEFT TURN - Move control towards left.
RIGHT TURN - Move control towards right.
ZERO RADIUS TURN - Move control diagonally
from neutral in desired direction.
DECK LIFT
ASSIST PEDAL
FIGURE 3.10
LEVER
SHOWN IN LOW
CUTTING HEIGHT
POSITION
WARNING
DO NOT make turns at high speed. Slow machine
motion. Move motion control lever gently and with
caution. DO NOT make sudden changes in speed or
direction.
12
Advertisement
Table of Contents
