Table of Contents
Advertisement
Section 3 - OPERATING
INSTRUCTIONS
3.1
PRE-START CHECK LIST
Make the following checks and perform the service
required before each start-up.
3.1.1. Check tires and add or release air as needed
to bring pressure to 12 psi in drive tires. Pressure in
front caster wheels should be 25 psi.
3.1.2. Check guards, deflectors and covers to make
sure all are in place and securely tightened.
3.1.3. Check engine oil and add oil as needed to
bring level up to the FULL mark.
Refer to engine
owner's manual for oil specifications. See Figure 3.1.
FIGURE 3.1
3.1.4. Check Blade Switch to insure it works freely.
1, Pull the Blade Switch up to the "ON" position to
engage or turn "ON" the mower blades.
2, Push Blade Switch down to the "OFF" position to
disengage or turn "OFF" the blades.
3,1,8.
Place
mower
in
desired
cutting
height
setting. Grasp deck lift lever and depress release
latch located underneath
the lever. Move lever to
desired
cutting
height setting
and release
latch.
Insert stop pin to desired cutting height.
IMPORTANT:
There is a foot assist pedal located
to the right front side of the footrest. Always use
this assist pedal to raise or lower the deck to the
desired cutting height. See Figure 3.3.
DECK LIFT
LEVER
RELEASE
LATCH
FOOT
ASSIST PEDAL
INSERT STOP PIN
INTO HOLES FOR
DESIRED CUTTING
HEIGHT
FIGURE 3.2
3.1.6. Clean
exterior
surfaces
of cutting
deck,
engine and pumps of any accumulation
of dirt,
grass, oil, etc.
Keep engine and pump air intake
screens and cooling fins clear at all times.
3.1.6. Add fuel
to both
tanks
of the
machine
outside where fumes can safely dissipate.
Make
sure both fuel filler caps are tight. Note the fuel tank
selector valve. Refer to engine owner's manual for
fuel specifications.
3.1.7. Adjust position of operator's seat. The seat
is mounted on slides. Locate latch lever beneath
the seat. Move lever towards the left and slide seat
to the desired position. Release latch.
FIGURE 3.3
IMPORTANT:
This
machine
is
equipped
with
hydrostatic
drive. The direction
of motion and the
speed of motion are controlled
by the motion control
lever (joystick).
A small movement
of this control can
cause the machine to move instantly.
DO NOT attempt
to operate the machine until you read this manual and
become familiar with its operation.
Practice
with the
blades
"OFF"
disengaged,
engine
speed at a slow
setting and in an open area away from obstacles.
allow
operation
of the
machin
personnel.
Advertisement
Table of Contents
