Annually (End Of Season); Changing Engine Oil; Changing Spark Plug; Maintenance And Service Parts - Snapper 10305 Safety Instructions & Operator's Manual

Section 3 - MAINTENANCE
:3.4
Perform all maintenance as
maintenance schedule.
3.4.1. Engine
Refer to engine
instructions.
3.4.2. Spark Plug
Refer to engine
instructions.
ANNUALLY (END OF EACH SEASON)
described in the
owner's manual for service
owner's manual for service
3.5 STORAGE PROCEDURE
Refer to the Engine Owner's Manual for directions
regarding engine storage preparations. Prepare the snow
thrower for "end of season" storage as follows:
1. Drain fuel from fuel tank and let engine run until
all fuel is out of the carburetor.
2. Disconnect and remove the spark plug wire
away from spark plug before any other
preparations are made!
3. Tape all openings closed to prevent spraying
water into exhaust or air intakes during washing.
4. Tilt snow thrower up on its wheels and
thoroughly clean the underside of the
auger/impeller.
5. Lubricate all exposed metal with a light coating
of oil to prevent corrosion.
6. Store the machine in a shed or other dry area,
protected from weather.
3.6 MAINTENANCE and SERVICE PARTS
MAINTENANCE and SERVICE PARTS
Au_ler Drive Belt (Briggs Engines)
Au_ler Drive Belt (Tecumseh Engines)
Wheel Drive Belt (Bri_l_lS En_lines)
Wheel Drive Belt (Tecumseh En_lines)
Scraper Blade (24" Width Au_ler)
Scraper Blade (26" Width Auger)
Scraper Blade (30" Width Au_lerI
Rubber Drive Tire
Shear Bolts - 5/16-18 x 1-7/8"
Hex Nuts - 5/16-18
Parts Manual for Large Frame Snow Throwers - Series 5
Models: 8245, 8265, E8265, 9265, E9265, 10305, E10305,
10305E, E10305E, N10305E
1-3937
1-3939
1-3936
2-9101
3-6122
3-9770
3-6006
1-0765
9-1550
9-1298
#06037
12