Regular Maintenance; Check / Clean Oil Cooler; Safety Interlock System Check; Blade Brake Check - Snapper Prestige 2800GT SERIES Operator's Manual

Regular M aintenance
CHECK / CLEAN OIL COOLER
(SELECT MODELS)
Service Interval: Every 25 Hours, or As Necessary
The engine oil cooler is located on the side of the engine
(A, Figure 19) and should be cleaned with compressed
air at regular intervals or if dirty.
SAFETY INTERLOCK SYSTEM
CHECK
Service Interval: Every Fall & Spring
Check the function of the safety interlock system using
the test procedure found on page 12 of this manual. If
the tractor fails any of the tests, see your dealer.
BLADE BRAKE CHECK
Service Interval: Every 100 Hours or Fall & Spring
Mower blades and mower drive belt should come to a
complete stop within five seconds after electric PTO
switch is turned off.
1. With tractor in neutral, PTO disengaged and operator
in seat, start the engine.
2. Look over the left-hand footrest at the mower drive
belt. Engage the PTO and wait several seconds.
Disengage the PTO and check the amount of time it
takes for the mower drive belt to stop.
3. If mower drive belt does not stop within five seconds,
re-adjust the clutch or see your dealer.
PTO CLUTCH ADJUSTMENT CHECK
Service Interval: After 25 Hrs, Then Every 250 Hrs
Check the PTO clutch adjustment after the initial 25 hour
break-in period and then after every 250 hours of opera-
tion-or if the clutch starts slipping or will not engage.
Check and adjust the clutch using the procedure outlined
in the Adjustments section of this manual.
ENGINE MAINTENANCE
Refer to the engine owner's manual for all engine main-
tenance procedures and recommendations.
Figure 19.
A. Oil Cooler
Clean Oil Cooler
22