Snapper NZM21520KWV Safety Instructions & Operator's Manual page 5

Mid mount z-rider zero turning hydro drive series 0
Hide thumbs Also See for NZM21520KWV:
Table of Contents

Advertisement

Section 3 - OPERATING
INSTRUCTIONS
3,2,1, STARTING ENGINE
NOTE: If after 5 seconds of cranking the engine
does not start, release the key. Attempt starting
again after waiting for approximately 20 seconds.
7. After engine starts, move the choke control to
the "OFF" or no choke position.
Allow a brief
warm-up until engine runs smooth.
3,2,2, STOPPING ENGINE
1. Stop engine by turning key to "STOP" position.
Move engine speed to the Turtle "SLOW" position
and turn key to "STOP". See Figure 3.6.
SHOWN FROM OPERATOR'S
VIEW POINT
FIGURE 3.6
j ,
WARNING
AI
DO NOT operate blades
in reverse. STOP blades. I
LOOK and SEE behind and down for children,
pets,
and hazards before and while backing.
I
3.2,3, STARTING MOWER BLADES
1. Start engine and set engine speed control to the
Rabbit "FAST" position. See Figure 3.5.
2. Pull the Blade Switch up to the "ON" position to
engage
or
turn
"ON"
the
mower
blades.
See Figure 3.2.
3.2,4, STOPPING MOWER BLADES
1. Push Blade Switch down to "OFF" position to
disengage or turn "OFF" the blades.
2. Move
engine
speed
control
to
the
Turtle
"SLOW" position. Turn key to "STOP" position.
WARNING
Once blades are disengaged, they should come to a
complete stop in 7 seconds. If the blades continue
to rotate after 7 seconds,
the electric clutch should
be checked. Adjustment
or replacement of electric
clutch may be necessary. Return the machine to an
authorized Snapper dealer for replacement. DO NOT
CONTINUE to operate mower if blades fail to stop in
7 seconds.
3,2,5. PARKING BRAKE
1, Engage parking
brake by pulling the parking
brake lever back to the engaged
position.
See
Figure 3.7.
NOTE:
Engaging parking
brake prior to placing
motion control levers in the neutral lock position
will cause engine to die. See Figure. 3.7.
3, Release
parking
brake
by pushing
parking
brake lever forward to the released position. See
Figure 3.8.
PARKING BRAKE
LEVER IN ENGAGED
"ON" POSITION
LEVER SHOWN IN
THE NEUTRAL
LOCK POSITION
FIGURE 3.7
FIGURE 3.8
PARKING BRAKE
LEVERIN
RELEASED
"OFF'POSITION
WARNING
DO NOT park the machine on slopes. DO NOT
machine
with engine running. Stop engine.
stop I
blades. Engage parking brake. Remove key.
|
12

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nzm19480kwv

Table of Contents